Dell 9.7(0.0) manual Ip address ip-address mask secondary

•Internet control message protocol (icmp) but not the ICMP message type (from 0 to 255)

•Any internet protocol (ip)

•Transmission Control Protocol (tcp) but not on the rst, syn, or urg bits

•User Datagram Protocol (udp)

In the case of ambiguous access control list rules, the debug ip packet access-controlcommand is disabled. A message appears identifying the error (refer to the Example below).

Example (Error Messages)

Dell#debug ip packet access-group test

%Error: port operator GT not supported in access-list debug

%Error: port operator LT not supported in access-list debug

%Error: port operator RANGE not supported in access-list debug

%Error: port operator NEQ not supported in access-list debug

Dell#00:10:45: %RPM0-P:CP

%IPMGR-3-DEBUG_IP_PACKET_ACL_AMBIGUOUS_EXP: Ambiguous rules not supported in access-list debug, access-list debugging is turned off

Dell#

ip address

Assign a primary and secondary IP address to the interface.

S6000

Syntax ip address ip-address mask [secondary]

Parameters

Defaults

Command Modes

Command History

To delete an IP address from an interface, use the no ip address [ip- address] command.

ip-address	Enter an IP address in dotted decimal format.
mask	Enter the mask of the IP address in slash prefix format (for
	example, /24).
secondary	(OPTIONAL) Enter the keyword secondary to designate the
	IP address as the secondary address.
Not configured.
INTERFACE

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

760 IPv4 Routing