Dell 9.7(0.0) manual Usage Information Example VersionDescription

Usage Information

Example

VersionDescription

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.9.1.0Added support for VRF.

7.8.1.0Added support for Multi-Process OSPF.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre- 6.1.1.1 Introduced on the E-Series.

You must have an IP address assigned to an interface to enter ROUTER OSPF mode and configure OSPF.

After the OSPF process and the VRF are tied together, you cannot use the OSPF Process ID again in the system.

Dell(conf)#router ospf 2

Dell(conf-router_ospf)#

show config

Display the non-default values in the current OSPF configuration.

S6000

Syntax	show config
Command	ROUTER OSPF
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.
	The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

Open Shortest Path First (OSPFv2 and OSPFv3) 1103