Dell 9.7(0.0) manual Name ipv6 Access-list

Defaults

Command Modes

Command History

	• 2c allows transmission of informs and counter 64, which
	allows for integers twice the width of what is normally
	allowed.
	The default is 1.
auth	(OPTIONAL) Enter the keyword auth to specify
	authentication of a packet without encryption.
noauth	(OPTIONAL) Enter the keyword noauth to specify no
	authentication of a packet.
priv	(OPTIONAL) Enter the keyword priv to specify both
	authentication and then scrambling of the packet.
read name	(OPTIONAL) Enter the keyword read then a name (a string
	of up to 20 characters long) as the read view name. The
	default is GlobalView and is assumed to be every object
	belonging to the internet (1.3.6.1) OID space.
write name	(OPTIONAL) Enter the keyword write then a name (a string
	of up to 20 characters long) as the write view name.
notify name	(OPTIONAL) Enter the keyword notify then a name (a
	string of up to 20 characters long) as the notify view name.
access access-	(Optional) Enter the standard IPv4 access list name (a string
list-name	up to 16 characters long).
ipv6 access-	(Optional) Enter the keyword ipv6 then the IPv6 access list
list-name	name (a string up to 16 characters long).
access-list-	(Optional) Enter both an IPv4 and IPv6 access list name.
name ipv6
access-list-
name
As above.
CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.10.2Added support for the access parameter.

Simple Network Management Protocol (SNMP) and Syslog 1487