Dell 9.7(0.0) manual Show spanning-tree

Example	Dell(conf)#protocol spanning-tree 0
	Dell(config-stp)#
Related	disable — disables spanning tree group 0. To enable spanning tree group 0, use the
Commands	no disable command.

show config

Display the current configuration for the mode. Only non-default values display.

Syntax	show config
Command	SPANNING TREE
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.
	The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.7.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.2.1.1Introduced on the E-Series.

Example	Dell(config-stp)#show config
	protocol spanning-tree 0
	no disable
	Dell(config-stp)#

show spanning-tree 0

Display the spanning tree group configuration and status of interfaces in the spanning tree group.

Syntaxshow spanning-tree 0 [active brief guard interface interface root summary]

Spanning Tree Protocol (STP) 1559