Usage Information

Example

VersionDescription

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.10.0Introduced on the S4810.

8.5.1.0Added support for 4-port 40G line cards on ExaScale.

8.1.1.0Introduced on the E-Series ExaScale.

7.9.1.0Introduced VRF on the E-Series.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre-6.1.1.0

Introduced on the E-Series.

This command provides egress port information for a given IP flow. This information is useful in identifying which interface the packet follows in the case of Port-channel and Equal Cost Multi Paths. Use this command for routed packed only. For switched packets, use the show port-channel-flowcommand.

The show ip flow command does not compute the egress port information when load-balance mac hashing is also configured due to insufficient information (the egress MAC is not available).

S-Series produces the following error message: %Error: Unable to read IP route table.

Dell#show ip flow interface te 2/42 20.1.1.1 100.1.1.2 protocol tcp

Flow: 20.1.1.1 100.1.1.2 6

Ingress interface: Te 2/42

Egress Interface: Te 2/43 Dell#

show ip interface

View IP-related information on all interfaces.

S6000

Syntaxshow ip interface [interface brief] [configured]

Parameters

interface(OPTIONAL)

Enter the following keywords and slot/port or number information:

•For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

798

IPv4 Routing

Page 798
Image 798
Dell 9.7(0.0) manual Show ip interface, Syntaxshow ip interface interface brief configured, InterfaceOPTIONAL