Dell 9.7(0.0) manual Privilege level Configuration mode, Mode, Level level, Reset

privilege level (CONFIGURATION mode)

Change the access or privilege level of one or more commands.

Syntaxprivilege mode {level level command reset command}

Parameters

Defaults

Command Modes

Command History

To delete access to a level and command, use the no privilege mode level level command command.

mode	Enter one of the following keywords as the mode for which
	you are controlling access:
	• configure for CONFIGURATION mode
	• exec for EXEC mode
	• interface for INTERFACE modes
	• line for LINE mode
	• route-mapfor ROUTE-MAP mode
	• router for ROUTER OSPF, ROUTER RIP, ROUTER ISIS
	and ROUTER BGP modes
level level	Enter the keyword level then a number for the access level.
	The range is from 0 to 15.
	Level 1 is EXEC mode and Level 15 allows access to all CLI
	modes and commands.
reset	Enter the keyword reset to return the security level to the
	default setting.
command	Enter the command’s keywords to assign the command to a
	certain access level. You can enter one or all of the
	keywords.
Not configured.
CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

1370 Security