Usage Information

VersionDescription

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

At least one of the routes included in the aggregate address must be in the BGP routing table for the configured aggregate to become active.

If routes within the aggregate are constantly changing, do not add the as-setparameter to the aggregate as the aggregate flaps to keep track of the changes in the AS_PATH.

In route maps used in the suppress-mapparameter, routes meeting the deny clause are not suppress; in other words, they are allowed. The opposite is also true: routes meeting the permit clause are suppressed.

If the route is injected via the network command, that route still appears in the routing table if the summary-onlyparameter is configured in the aggregate- address command.

The summary-onlyparameter suppresses all advertisements. If you want to suppress advertisements to only specific neighbors, use the neighbor distribute-listcommand.

In the show ip bgp command, aggregates contain an ‘a’ in the first column and routes suppressed by the aggregate contain an ‘s’ in the first column.

When an aggregate address is denied using a peer's outbound route-map, individual routes suppressed by the aggregate address are advertised to that peer.

The attribute-map corresponding to an aggregate address is applied during the outbound update creation time; hence the value set in that attribute-map will not be shown in the output of the show ip bgp aggregate route command.

bgp add-path

Allow the advertisement of multiple paths for the same address prefix without the new paths replacing any previous ones.

S6000

Syntax

bgp add-path [send receive both] path-count

Parameters

send

Enter the keyword send to indicate that the system sends

 

multiple paths to peers.

Border Gateway Protocol

339

Page 339
Image 339
Dell 9.7(0.0) manual Usage Information VersionDescription, Bgp add-path send receive both path-count, Parameters Send