Dell 9.7(0.0) manual Ip multicast-routing, Ip multicast-limit command is reached

Parameters	vrf vrf-name	(OPTIONAL) Enter the keyword vrf followed by the name of
		the VRF to limit the number of multicast on the VRF.
	limit	Enter the desired maximum number of multicast entries on
		the system. The S-Series range is from 1 to 16000.
Defaults	The S-Series default is 4000.
Command	CONFIGURATION
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Added support for VRF. Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the C-Series.

7.6.1.0Introduced on the E-Series.

Usage	This feature allows you to limit the number of multicast entries on the system. This
Information	number is the total of all the multicast entries on all line cards in the system. On
	each line card, the multicast module only installs the maximum number of entries,
	depending on the configured CAM profile.
	To store multicast routes, use the IN-L3-McastFib CAM partition. It is a separate
	hardware limit that exists per port-pipe. This hardware space limitation can
	supersede any software-configured limit. The opposite is also true, the CAM
	partition might not be exhausted at the time the system-wide route limit set by the
	ip multicast-limit command is reached.
Related	show ip igmp groups — shows the IGMP groups.
Commands

ip multicast-routing

Enable IP multicast forwarding.

S6000

Syntax	ip multicast-routing [vrf vrf-name]
	To disable multicast forwarding, use the no ip multicast-routing [vrf
	vrf-name]command.

Multicast 1015