ip igmp access-group

To specify access control for packets, use this feature.

S6000

Syntax

ip igmp access-group access-list

Parameters

Defaults

Command Modes

Command History

Usage Information

To remove the feature, use the no ip igmp access-group access-list command.

access-list

Enter the name of the extended ACL (16 characters

 

maximum).

 

Enter the name of the extended ACL (139 characters

 

maximum).

Not configured

INTERFACE (conf-if-interface-slot/port)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the C-Series and S-Series.

7.6.1.0Introduced on E-Series.

The access list accepted is an extended ACL. To block IGMP reports from hosts, on a per-interface basis based on the group address and source address that you specify in the access list, use this feature.

ip igmp immediate-leave

Enable IGMP immediate leave.

S6000

Syntaxip igmp immediate-leave [group-list prefix-list-name]

Internet Group Management Protocol (IGMP)

641

Page 641
Image 641
Dell 9.7(0.0) manual Ip igmp immediate-leave, Ip igmp access-group access-list