Dell 9.7(0.0) manual Show ip flow, Number tcp, Src-port

ip ecmp weighted— enables weighted ECMP calculations.

show ip flow

Show how a Layer 3 packet is forwarded when it arrives at a particular interface.

S6000

Syntax

Parameters

Command Modes

Command History

show ip flow interface interface {source-ip address destination-ip address} {protocol number [tcp udp]} {src-port number destination-port number}

interface	Enter the keyword interface then one of the following
interface	interface keywords.
	• For a 10-Gigabit Ethernet interface, enter the keyword
	TenGigabitEthernet then the slot/port information.
	• For a 40-Gigabit Ethernet interface, enter the keyword
	fortyGigE then the slot/port information.
source-ip	Enter the keywords source-ipthen the IP source address
address	in IP address format.
destination-ip	Enter the keywords destination-ipthen the IP
address	destination address in IP address format.
protocol	Enter the keyword protocol then one of the protocol type
number [tcp	keywords: tcp, udp, or protocol number The protocol
udp]	number range is from 0 to 255. .
src-port	Enter the keywords src-portthen the source port number.
number
destination-	Enter the keywords destination-portthen the destination
port number	port number.
EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

IPv4 Routing 797