Dell 9.7(0.0) manual VRF to display BGP keepalive information corresponding

Parameters

Command Modes

Command History

Usage Information

To disable debugging, use the no debug ip bgp [vrf vrf-name] [A.B.C.D X:X:X:X::X peer-grouppeer-group-name] keepalives [in out] command.

vrf vrf-name	(OPTIONAL) Enter the keyword vrf followed by the name of
	the VRF to display BGP keepalive information corresponding
	to that VRF.
A.B.C.D	(OPTIONAL) Enter the IPv4 address of the neighbor.
X:X:X:X::X	(OPTIONAL) Enter an IPv6 address.
peer-group	(OPTIONAL) Enter the keyword peer-groupthen the name
peer-group-	of the peer group.
name
in	(OPTIONAL) Enter the keyword in to view only inbound
	keepalive messages.
out	(OPTIONAL) Enter the keyword out to view only outbound
	keepalive messages.
EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

To remove all configured debug commands for BGP, enter the no debug ip bgp command.

372 Border Gateway Protocol