Dell 9.7(0.0) manual Log-adjacency-changes, Lsp-gen-interval, Level-l

log-adjacency-changes

Generate a log messages for adjacency state changes.

Syntax	log-adjacency-changes
	To disable this function, use the no log-adjacency-changescommand.
Defaults	Adjacency changes are not logged.
Command	ROUTER ISIS
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.
	The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.12.0Introduced on the S4810.

8.3.11.1Introduced on the Z9000.

Usage	This command allows you to monitor adjacency state changes, which are useful
Information	when you monitor large networks. Messages are logged in the system’s error
	message facility.

lsp-gen-interval

Set the minimum interval between successive generations of link-state packets (LSPs).

Syntaxlsp-gen-interval [level-l level-2] interval seconds [initial_wait_interval seconds [second_wait_interval seconds]]

To restore default values, use the no lsp-gen-interval[level-l level-2]interval seconds [initial_wait_interval seconds [second_wait_interval seconds]] command.

Parameters	(OPTIONAL) Enter the keywords level-1to apply the
level-l
	configuration to generation of Level-1 LSPs.
level-2	(OPTIONAL) Enter the keywords level-2to apply the
	configuration to generation of Level-2 LSPs.

878 Intermediate System to Intermediate System (IS-IS)