Dell 9.7(0.0) manual Permit, Syntaxpermit ipv6-protocol-number icmp ipv6 tcp udp

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.7.0Introduced on the S4810.

8.4.2.1Introduced on the S-Series.

8.2.1.0Introduced on the E-Series ExaScale.

7.8.1.0Introduced on the C-Series.

7.4.1.0Introduced on the E-Series TeraScale. Added the monitor option.

permit

To configure a filter that matches the filter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, or UDP.

Syntaxpermit {ipv6-protocol-number icmp ipv6 tcp udp}

To remove this filter, you have two choices:

•Use the no seq sequence-numbercommand syntax if you know the filter’s sequence number

•Use the no permit {ipv6-protocol-number icmp ipv6 tcp udp} command

Parameters

Defaults

Command Modes

Command History

ip-protocol-	Enter an IPv6 protocol number. The range is from 0 to 255.
number
icmp	Enter the keyword icmp to filter internet Control Message
	Protocol version 6.
ipv6	Enter the keyword ipv6 to filter any internet Protocol
	version 6.
tcp	Enter the keyword tcp to filter the Transmission Control
	protocol.
udp	Enter the keyword udp to filter the User Datagram Protocol.
Not configured.
ACCESS-LIST

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

834 IPv6 Access Control Lists (IPv6 ACLs)