Getting started
Battery charging
Once you have installed the battery, the screen indicates the battery status (see the table below). If necessary, place the handset in the telephone base or charger to charge the battery. For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 16 hours of continuous charging. See the table on page 25 for battery operating times.
If the screen is blank, you need to charge the handset without interruption for at least 30 minutes to give the handset enough charge to use the telephone for a short time. When the battery is low, the handset displays Low battery along with a flashing icon. If you are on a call in low battery mode, the handset beeps every 50 seconds.
The following table summarizes the battery charge indicators and actions to take.
Battery indicators | Battery status | Action | ||||
The screen is blank, | Battery has very little or | Charge without interruption | ||||
or displays Place in | no charge. The handset | (at least 30 minutes). | ||||
charger and |
| flashes. | cannot be used. |
| ||
|
|
|
|
|
|
|
The screen displays | Battery has enough | Charge without interruption | ||||
Low battery and | charge to be used for a | (about 30 minutes). | ||||
|
| flashes. | short time. |
| ||
|
|
|
|
|
|
|
The screen displays | Battery is charged. | To keep the battery charged, | ||||
HANDSET X and |
| place it in the telephone | ||||
|
|
| base or charger when not | |||
|
|
|
|
|
| in use. |
If you place the handset in the telephone base or charger without plugging in the battery, the screen displays No battery.
Telephone base layout
IN USE light
On when the handset is in use.
Flashes quickly when there is an incoming call.
Flashes when another telephone sharing the same line is in use.
/FIND HANDSET
Press once and then release to page all system handsets (page 12).
