Pentair installation manual Electrical, Installation contd, MiniMax CH Millivolt Wiring Diagram

Installation (contd.) 17

ELECTRICAL

MiniMax CH Millivolt Wiring Diagram

MINIMAX WIRING DIAGRAM (MILLIVOLT) DUAL THERM (HONEYWELL ELECTRONIC)

IF ORIGINAL FACTORY WIRING MUST BE REPLACED, INSTALLER MUST SUPPLY UL OR CSA (IF CANADA) APPROVED WIRE, 18 GAUGE, 600V, 105 C˚ TEMPERATURE RATING. THERMAL FUSE WIRING MUST BE REPLACED WITH UL OR CSA (IF CANADA) APPROVED WIRE, 18 GAUGE, 600V, 125 C˚ TEMPERATURE RATING. INTERCONNECTING WIRING TO APPLIANCE MUST CONFORM TO THE NATIONAL ELECTRICAL CODE OR SUPERCEDING LOCAL (WIRING) CODES.

		PILOT
TH/PP	WHT	GENERATOR
	RED
TH	PP		SAFETY	PRESS
GAS VALVE
		HI-LIMIT	SHUT-OFF	SWITCH
WHT		WHT	WHT	WHT

THERMAL

CUT-OFF

ORN

WHT

WHT

TH/PP

PP TH

POT 1 POT 2

THERMOSTAT BOARD

SEN	POT
	SENSOR

POOL

OFF

SPA

Figure 19.

NOTE: When connecting a remote control to the MiniMax CH, you must install the low voltage thermostat wires in separate conduit from ANY line voltage wires. Failure to follow these instructions will cause the thermostat relay to react erratically.

Rev. C 1-22-04 P/N 472128