Pentair CH Warranty Information, Product Identification, Safety Rules, Operation contd

Operation (contd.) 4

This instruction manual provides operating instructions, installation and service information for the MiniMax CH high performance heater. The information in this manual applies to the MiniMax CH 150, 200, 250, 300, 350, and 400 natural gas and propane (LP) models.

It is very important that the owner/installer read and understand the section covering installation instructions, and recognize the local and state codes before installing the MiniMax CH. History and experience has shown that most heater damage is caused by

improper installation practices.

WARRANTY INFORMATION

The MiniMax CH pool heater is sold with a limited factory warranty. Specific details are described on the warranty registration card which is included with the product. Return the warranty registration card after filling in the serial number from the rating plate inside the heater.

Pentair Pool Products’ high standards of excellence include a policy of continuous product improvement resulting in your state- of-the-art heater. We reserve the right to make improvements which change the specifications of the heater without incurring an obligation to update the current heater equipment.

PRODUCT IDENTIFICATION

To identify the heater, see rating plate on the inner front panel of the heater. There are two designators for each heater, one is the Model Number and the other is the Heater Identification Number (HIN).

a.Model Number: Example: 400

1st through 3rd character indicated: Input rating (Btu/hr) X 1000 b. Heater Identification Number (HIN):

The following example simplifies the identification system.

1	2	3	4	5	6
HTR	400	CH	Blank	N M	Blank

1)HTR : Heater

2)(150, 200, 250, 300, 400) : Input rating (Btu/hr) X 1000

3)CH : MiniMax CH

4)Blank : Standard Model

5)N M : Gas type (Natural gas) & Ignition Device

6)Options :

Blank: Standard Model

ASME: ASME Certified (Bronze Headers)

ASHI: ASME Certified Bronze Header & High Altitude Rating

HALT: High Altitude Rating

CAN: Canadian Compliance

CANH: Canadian Compliance and High Altitude

Operation

SAFETY RULES

1.Spa or hot tub water temperatures should never exceed 104° F (40° C). A temperature of 100° F (38° C) is considered safe for a healthy adult. Special caution is suggested for young children.

2.Drinking of alcoholic beverages before or during spa or hot tub use can cause drowsiness which could lead to unconsciousness and subsequently result in drowning.

3.Pregnant women beware! Soaking in water above 102° F (39° C) can cause fetal damage during the first three months of pregnancy (resulting in the birth of a brain-damaged or deformed child). Pregnant women should stick to the 100° F (38° C) maximum rule.

4.Before entering the spa or hot tub, the user should check the water temperature with an accurate thermometer. Spa or hot tub thermostats may err in regulating water temperatures by as much as 4° F (2.2° C).

5.Persons with a medical history of heart disease, circulatory problems, diabetes or blood pressure problems should obtain their physician's advice before using spas or hot tubs.

6.Persons taking medication which induce drowsiness, such as tranquilizers, antihistamines or anticoagulants should not use spas or hot tubs.

WARNING

Should overheating occur or the gas supply fail to shut off, turn off the manual gas control valve to the appliance. Do not use this heater if any part has been under water. Immediately call a qualified service technician to inspect the heater and to replace any part of control system and gas control which has been under water.

P/N 472128 Rev. C 1-22-04