3Com MSR 30, MSR 50 Vty-switch priority, Vty-switch threshold, Syntax vty-switch threshold times

926CHAPTER 70: TERMINAL ACCESS CONFIGURATION COMMANDS

source source-ip: Source IP address bound.

Description Use the vty tty remote command to create a VTY for TTY terminal access.

Use the undo vty command to remove the specified VTY.

Note that, after this configuration, no more RTC client VTYs or RTC server VTYs can be configured in the template of the VTY.

Example # Create VTY 1 for TTY terminal access, setting FEP IP address to 1.1.1.1, listening port number to 9010, and source IP address to 2.2.2.2.

<Sysname> system-view [Sysname] rta template abc

[Sysname-rta-template-abc] vty 1 tty remote 1.1.1.1 9010 source 2.2.2.2

vty-switch priority

Syntax vty-switch priority

undo vty-switch priority

View Terminal template view

Parameters None

Description Use the vty-switch priority command to configure the RTC server to perform VTY switching based on priority.

Use the undo vty-switch priority command to restore the default setting.

By default, the VTY switching is performed not based on priority.

This command takes effect in RTC terminal access. When VTY switching is performed based on priority (the lower the VTY number, the higher the priority), if the VTY number corresponding to the connection request received is less than the VTY number corresponding to the existing connection, the RTC server tears down the existing connection and begins to use the new connection for communication. If a connection has been established and this command is not used, any newer connection will be torn down.

Example # Configure the RTC server to perform VTY switching based on priority.

<Sysname> system-view

[Sysname] rta template abc

[Sysname-rta-template-abc] vty-switch priority

vty-switch threshold

Syntax vty-switch threshold times