3Com MSR 50, MSR 30 manual Fr lmi type ansi nonstandard q933a bi-direction, Undo fr lmi type

395

Example # Set the frame relay interface Serial 2/0 to operate in DCE mode and set T392 to 10s.

<Sysname> system-view [Sysname] interface serial2/0 [Sysname-Serial2/0] link-protocol fr

[Sysname-Serial2/0] fr interface-type dce

[Sysname-Serial2/0] fr lmi t392dce 10

fr lmi type

Syntax	fr lmi type { ansi nonstandard q933a } [ bi-direction ]
	undo fr lmi type
View	Interface view
Parameter	ansi: Standard LMI protocol type of ANSI T1.617 Appendix D.
	nonstandard: Nonstandard compatible LMI protocol type.
	q933a: Standard LMI protocol type of Q.933 Appendix A.
	bi-direction: Specifies to respond to status-enquiry messages from network side
	in frame relay DTE mode. The support of this keyword varies with device models.
Description	Use the fr lmi type command to configure the frame relay LMI protocol type.
	Use the undo fr lmi type command to restore the default.
	By default, the LMI protocol type is q933a.
	LMI protocol is used to maintain frame relay protocol PVC table, including
	notifying PVC increasing, detecting PVC deleting, monitoring PVC status changing
	and authenticating link integrity. The system usually supports three standard LMI
	protocols ITU-T Q.933 Appendix A, ANSI T1.617 Appendix D, and
	nonstandard-compatible LMI protocol.
	The bi-directionkeyword specifies the interface to respond to status enquiry
	messages form network side when operating in frame relay DTE mode. It does not
	enable frame relay network specifications of the network side and has no effect
	on frame relay DCE interfaces. Normally, this keyword is only needed when the
	current device is to communicate with routers that require bi-directional LMI, such
	as Motorola Vanguard 5.3 (or former versions).
Example	# Set the frame relay LIMI type of Serial 2/0 to nonstandard compatible protocol.
	<Sysname> system-view
	[Sysname] interface serial 2/0
	[Sysname-Serial2/0] fr lmi type nonstandard