3Com MSR 50, MSR 30 manual Undo special-character character number, Different signal values

	2669
	undo special-character character number
View	R2 CAS view
Parameter	character: Special character, which can be a pound sign (#) or asterisk (*), A, B, C,
	or D.
	number: Code of register signal, in the range 11 to 16.
Description	Use the special-charactercommand to configure the special characters
	acceptable during register signal exchange.
	Use the undo special-charactercommand to remove the configured special
	characters.
	By default, no special characters are configured.
	This command applies to R2 signaling only.
	You may need to configure this command to accommodate to some national R2
	signaling variants where Group I forward signals can represent special characters
	such as pound signs (#) and asterisks (*) in addition to digits.
n	■ You cannot use the special-charactercommand to assign a special character
	different signal values.
	■ To ensure that the device can process calls correctly, assign special characters
	different signal values.
Example	# Assign the pound sign (#) the register signal code 11.
	<Sysname> system-view
	[Sysname] controller e1 1/0
	[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
	[Sysname-e1 1/0] cas 0
	[Sysname-cas1/0:0] special-character # 11
subscriber line
Syntax	subscriber line slot-number:{ts-set-number 15 23 }
View	Voice view
Parameter	slot-number: Number of the voice subscriber line automatically created upon
	creation of a TS group or ISDN PRI set.
	ts-set-number: Number of the TS group that has been created.
	15: Indicates the subscriber line is created for the ISDN PRI set created on an E1
	interface.