3Com MSR 50, MSR 30 manual Display ipv6 neighbors count, Static vlan vlan-id count

				835
IPv6 Address	Link-layer	VID Interface	State	T Age
FE80::200:5EFF:FE32:B800 0000-5e32-b800		N/A Eth1/0	REACH S	-
Table 176 Description on fields of the display ipv6 neighbors command
Field	Description
IPv6 Address	IPv6 address of a neighbor
Link-layer	Link layer address (MAC address of a neighbor)
VID	VLAN to which the interface connected with a neighbor belongs
Interface	Interface connected with a neighbor
State	State of a neighbor, including:
	■ INCMP: The address is being resolved. The link layer address of the
	neighbor is unknown.
	■ REACH: The neighbor is reachable.
	■ STALE: The reachability of the neighbor is unknown. The device will
	not verify the reachability any longer unless data is sent to the
	neighbor.
	■ DELAY: The reachability of the neighbor is unknown. The device
	sends an NS message after a delay.
	■ PROBE: The reachability of the neighbor is unknown. The device
	sends an NS message to verify the reachability of the neighbor.
T	Type of neighbor information, including static configuration and
	dynamic acquisition.
Age	For a static entry, a hyphen “-” is displayed. For a dynamic entry, the
	reachable time (in seconds) elapsed is displayed, and if it is never
	reachable, “#” is displayed (for a neighbor acquired dynamically).

display ipv6 neighbors count

Syntax	display ipv6 neighbors { all dynamic interface interface-typeinterface-number
	static vlan vlan-id} count
View	Any view
Parameter	all: Displays the total number of all neighbor entries, including neighbor entries
	acquired dynamically and configured statically.
	dynamic: Displays the total number of all neighbor entries acquired dynamically.
	static: Displays the total number of neighbor entries configured statically.
	interface interface-typeinterface-number: Displays the total number of neighbor
	entries of a specified interface.
	vlan vlan-id: Displays the total number of neighbor entries of a specified VLAN
	whose ID ranges from 1 to 4094.
Description	Use the display ipv6 neighbors count command to display the total number
	of neighbor entries satisfying the specified condition.

Example # Display the total number of neighbor entries acquired dynamically.