1021

debugging bgp

Syntax debugging bgp [ ipv4-address ipv6-address] { keepalive open packet raw-packet route-refresh } [ receive send ] [ verbose ] }

undo debugging bgp [ ipv4-address ipv6-address] { keepalive open packet raw-packet route-refresh } [ receive send ] [ verbose ] }

View User view

Default Level 1: Monitor level

Parameters ipv4-address: IPv4 address of a peer. ipv6-address: IPv6 address of a peer.

keepalive: Enables BGP Keepalive message debugging.

open: Enables BGP OPEN message debugging.

packet: Specifies to enable BGP packet debugging

raw-packet: Enables BGP raw packet debugging.

route-refresh: Enables BGP Route-Refresh message debugging.

receive: Enables the debugging for received BGP packets.

send: Enables the debugging for sent BGP packets.

verbose: Displays detailed debugging information.

Description Use the debugging bgp command to enable debugging for specific BGP message types.

Use the undo debugging bgp command to disable debugging for specific BGP message types.

Enabling debugging may affect system performance; therefore, use the command only when necessary and disable debugging once the debugging operation is complete.

By default, this debugging is disabled.

Table 226 Description on the fields of the debugging bgp command

Field

Description

 

 

Recv

Received packets

Send

Sent packets

Length: LengthNumber

Packet length

 

 

Page 1021
Image 1021
3Com MSR 50, MSR 30 manual Debugging bgp, Description on the fields of the debugging bgp command, 1021