3Com MSR 30, MSR 50 Sdlc max-transmission, Sdlc modulo, View Synchronous serial interface view

364CHAPTER 21: BASIC DLSW CONFIGURATION COMMANDS

Description Use the sdlc max-send-queuecommand to configure the length of the SDLC output queue.

Use the undo sdlc max-send-queuecommand to restore the default setting.

By default, the length of the SDLC output queue is 50.

Example # Set the length of the SDLC output queue to 30 on Serial 2/0.

<Sysname> system-view

[Sysname] interface serial 2/0

[Sysname-Serial2/0] sdlc max-send-queue 30

sdlc max-transmission

Syntax sdlc max-transmission retries

undo sdlc max-transmission

View Synchronous serial interface view

Parameter retries: Maximum number of SDLC transmission retries, in the range of 1 to 255 times.

Description Use the sdlc max-transmissioncommand to configure the maximum number of SDLC transmission retries, namely the number of times a frame is retransmitted before an acknowledgment is received from the peer.

Use the undo sdlc max-transmissioncommand to restore the default setting.

By default, the maximum number of SDLC transmission retries is 20.

Example # Set the maximum SDLC transmission retries to 30 on Serial 2/0.

<Sysname> system-view

[Sysname] interface serial 2/0

[Sysname-Serial2/0] sdlc max-transmission 30

sdlc modulo

Syntax	sdlc modulo { 8 128 }
	undo sdlc modulo
View	Synchronous serial interface view
Parameter	8: Specifies the modulus value to be 8.
	128: Specifies the modulus value to be 128.