3Com MSR 30, MSR 50 manual Portal resource-name, Related command display portal free-rule

2076 CHAPTER 135: PORTAL CONFIGURATION COMMANDS

all: Specifies all authentication-free rules.

Description Use the portal free-rulecommand to configure a portal authentication-free rule, namely, to specify a source filtering condition or destination filtering condition.

Use the undo portal free-rulecommand to remove the authentication-free rule.

If you specify both the source IP and source MAC address information in a portal-free rule, the IP address must be a host address with a mask of 32 bits; otherwise, the specified MAC address will be neglected.

Related command: display portal free-rule.

Example # Configure a portal authentication-free rule where the packets whose source IP address is 10.10.10.1/24, source interface is Ethernet 1/0, and destination IP address is any address will not trigger a portal authentication.

<Sysname> system-view

[Sysname] portal free-rule 15 source ip 10.10.10.1 mask 24 interface

ethernet 1/0 destination ip any

portal resource-name

Syntax portal resource-name resource-name

undo portal resource-name

View System view

Parameter resource-name: Name of the resource to be protected, a case-sensitive string of 1 to 32 characters.

Description Use the portal resource-namecommand to configure a name for the resource to be protected.

Use the undo portal resource-namecommand to remove the configuration.

By default, the name of the resource to be protected is not specified.

n This command only applies to the devices with portal+ enabled.

Example # Configure the name of the resource to be protected as portal-info-center.

<Sysname> system-view

[Sysname] portal resource-name portal-info-center