3Com MSR 30, MSR 50 manual Display isdn spid, Isdn, Kbri, Kpri

568CHAPTER 37: ISDN CONFIGURATION COMMANDS

T32130

T3224

Table 97 Description of the fields of the display isdn parameters command

Item	Description
T200(sec)	Retransmit-timer (in seconds) of the L2 protocol of ISDN
T201(sec)	TEI test request retransmit-timer (in seconds) of the L2 protocol of
	ISDN
T202(sec)	TEI request retransmit-timer (in seconds) of the ISDN L2 protocol
T203(sec)	The maximum link idle time (in seconds) of the ISDN L2 protocol
N200	The maximum number of retransmissions
K(BRI)	The maximum number of unacknowledged frames (slide window
	size) on the ISDN BRI port
K(PRI)	The maximum number of unacknowledged frames (slide window
	size) on the ISDN PRI port
Timer-Number	ISDN L3 timer
Value(sec)	Duration (in seconds) of each ISDN L3 timer

display isdn spid

Syntax display isdn spid [ interface interface-type interface-number ]

View Any view

Parameter interface-typeinterface-number:Specifies an interface by its type and number.

Description Use the display isdn spid command to view information on SPID on the BRI interface encapsulated with the NI protocol.

You may execute this command to view the SPID type, SPID value and some other information when ISDN is running. Executing this command without specifying an interface, you may view information on SPI on all the SPID-supported BRI interfaces.

Example # Display the related information of SPID on the NI-supported interface BRI 1/0.

<Sysname> display isdn spid interface bri 1/0 Interface Bri1/0 :

SPID Type: AUTO

SPID B1:

SPID Num:

Neg State: SPID_UNASSIGNED

Init State: INIT_NULL

SPID B2:

SPID Num:

Neg State: SPID_UNASSIGNED

Init State: INIT_NULL