3Com MSR 30, MSR 50 manual Dot1x max-user, Undo dot1x max-user interface interface-list

1904 CHAPTER 126: 802.1X CONFIGURATION COMMANDS

dot1x max-user

Syntax In system view:

dot1x max-useruser-number [ interface interface-list ]

undo dot1x max-user [ interface interface-list]

In Ethernet interface view:

dot1x max-user user-number

undo dot1x max-user

View System view/interface view

Parameter user-number: Maximum number of users to be supported simultaneously. The valid settings and the default may vary by device.

interface interface-list: Specifies an Ethernet port list, which can contain multiple Ethernet ports. The interface-listargument is in the format of interface-list=

{interface-type interface-number [ to interface-type interface-number ] } & <1-10>, where interface-type represents the port type, interface-number represents the port number, and & <1-10> means that you can provide up to 10 port indexes/port index lists for this argument. The start port number must be smaller than the end number and the two ports must of the same type.

Description Use the dot1x max-usercommand to set the maximum number of users to be supported simultaneously for specified or all ports.

Use the undo dot1x max-usercommand to restore the default.

Note that:

■With no interface specified, the command sets the threshold for all ports when issued in system view.

■When issued in interface view, this command applies to that port only. The interface interface-listkeyword and argument are not available in interface view.

Related command: display dot1x.

Example # Set the maximum number of users for port Ethernet 1/1 to support simultaneously as 32.

<Sysname> system-view

[Sysname] dot1x max-user 32 interface ethernet 1/1

Or