3Com MSR 30, MSR 50 manual Gw-id, Undo gw-address, Undo gw-id

2696 CHAPTER 177: H.323 CONFIGURATION COMMANDS

undo gw-address

View Gatekeeper client view

Parameter ip-address: Source IP address to be bound to the voice gateway.

Description

c

Use the gw-addresscommand to bind a source IP address with the voice gateway.

Use the undo gw-addresscommand to remove the binding.

By default, no source IP address is bound to the voice gateway.

CAUTION:

■Use this command before configuring the ras-oncommand. In case the latter has been configured, undo it first.

■To make calls successfully, ensure that the source IP address is a valid IP address already assigned to an Ethernet or loopback interface on the device, and in addition, this address and the address of the peer H.323 entity (a gatekeeper, terminal, or MCU) are reachable to each other.

Related command: area-id,gk-2nd-id,gk-id,gw-address, and ras-on.

Example # Bind the source IP address 1.1.1.1 to the voice gateway.

<Sysname> system-view

[Sysname] voice-setup

[Sysname-voice] gk-client

[Sysname-voice-gk] gw-address 1.1.1.1

gw-id

Syntax gw-idnamestring

undo gw-id

View Gatekeeper client view

Parameter namestring: Gateway alias (gateway identifier), a string of 1 to 128 case-sensitive characters.

Description Use the gw-idcommand to assign an alias to the gateway. This alias overwrites the old one, if any.

Use the undo gw-idcommand to remove the alias.

By default, no alias is assigned to the gateway.

Note that each gateway can be assigned only one alias. It is used by the gatekeeper to identify the gateway.