3Com MSR 50 Cid send, Cid type, Syntax cid send Undo cid send, Syntax cid type complex simple

2557

■If a number is configured in the number template for the POTS entity associated with the local FXO interface, the interface substitutes this number for the calling number and sends it to the called side.

■If wildcard dots (.) are used in the number configured in the number template for the POTS entity associated with the local FXO interface, the interface substitutes zeros for the calling number’s digits in the place of dots, for example, 1000 for 1... and then sends the substitution number to the called side.

Example # Enable CID on voice subscriber line 1/0.

<Sysname> system-view [Sysname] voice-setup [Sysname-voice] subscriber-line 1/0 [Sysname-voice-line1/0] cid receive

cid send

Syntax cid send

undo cid send

View FXS/FXO voice subscriber line view

Parameter None

Description Use the cid send command to enable the FXS or FXO voice subscriber line to send calling numbers to the remote end.

Use the undo cid send command to disable the FXS or FXO voice subscriber line from send calling numbers to the remote end.

By default, the FXS or FXO voice subscriber line sends calling numbers to the remote end.

After you configure the undo cid send command, the FXS or FXO voice subscriber line will not send any calling number to the called side, whether the originating side has sent it or it is configured in the number template for the voice entity associated with the FXS or FXO voice subscriber line.

Example # Disable voice subscriber line 1/0 from sending calling numbers to the IP network.

<Sysname> system-view [Sysname] voice-setup [Sysname-voice] subscriber-line 1/0 [Sysname-voice-line1/0] undo cid send

cid type

Syntax cid type { complex simple }