3Com MSR 50, MSR 30 manual Poe enable, Syntax poe enable Undo poe enable

	2497
View	System view
Parameter	ac: Specifies the PD disconnection detection mode as ac mode.
	dc: Specifies the PD disconnection detection mode as dc mode.
Description	Use the poe disconnect command to configure a PD disconnection detection
	mode.
	Use the undo poe disconnect command to restore the default PD disconnection
	detection mode.
	The default PD disconnection detection mode depends on the device model.
	Note that a change to the PD disconnection detection mode may lead to a
	power-off of some PDs.
Example	# Set the PD disconnection detection mode to dc.
	<Sysname> system-view
	[Sysname] poe disconnect dc

poe enable

Syntax poe enable

undo poe enable

View PoE interface view/PoE-profile file view

Parameter None

Description Use the poe enable command to enable PoE on a PoE interface.

Use the undo poe enable command to disable PoE on a PoE interface.

By default, PoE is disabled on a PoE interface.

c CAUTION:

■If a PoE configuration file is already applied to a PoE interface, you need to remove the application of the file to the PoE interface before configuring the interface in PoE-profile view.

■If a PoE configuration file is applied to a PoE interface, you need to remove the application of the file to the PoE interface before configuring the interface in PoE interface view.

Example # Enable PoE on a PoE interface.

<Sysname> system-view

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0]poe enable