3Com MSR 30, MSR 50 manual Statistics interval, Tracert lsp, Syntax tracert lsp -a source-ip-exp

1562 CHAPTER 95: MPLS BASICS CONFIGURATION COMMANDS

Related command: static-lsp egress, static-lsp ingress.

Example # Configure a static LSP, taking interface Serial 2/0 as the incoming interface and setting the incoming label as 123 and the outgoing label as 253.

<Sysname> system-view

[Sysname] static-lsp transit bj-sh incoming-interface serial 2/0 in-

label 123 nexthop 202.34.114.7 out-label 253

statistics interval

Syntax statistics interval interval-time

undo statistics interval

View MPLS view

Parameter interval-time: Statistics Interval, in the range 30 to 65,535 seconds.

Description Use the statistics interval command to set the statistics interval, that is, the interval for collecting statistics.

Use the undo statistics interval command to restore the default.

By default, the interval is 0.

Related command: display mpls statistics interface, display mpls statistics lsp.

Example # Set the statistics interval to 30 seconds.

<Sysname> system-view [Sysname] mpls

[Sysname-mpls] statistics interval 30

tracert lsp

Syntax tracert lsp [-a source-ip-exp

{ipv4 dest-addr mask-length [ interface-number }

exp-value -httl-value -rreply-mode -ttime-out ] * destination-ip-addr-header ] te interface-type

View	Any view
Parameter	-asource-ip: Specifies the source address for the echo request message.
	-expexp-value: Specifies the EXP value for the echo request message. The
	exp-valueargument ranges from 0 to 7.
	-httl-value: Specifies the TTL value for the echo request message. The ttl-value
	argument ranges from 1 to 255.