3Com MSR 50, MSR 30 manual 2487

2487

Port Operating Status	: on
Port IEEE Class	: 1
Port Detection Status	: delivering-power
Port Power Mode	: signal
Port Current Power	: 11592	mW
Port Average Power	: 11610	mW
Port Peak	: 11684	mW
Port Max Power	: 15400	mW
Port Current	: 244	mA
Port Voltage	: 51.7	V
Port PD Description	: IP Phone For Room 101

Table 640 Description on fields of the display poe interface ethernet command

Field	Description
Port Power Enabled	PoE enabled/disabled state
	■ enable: PoE is enabled.
	■ disable: PoE is disabled.
Port Power Priority	Power priority of the PoE interface:
	■	critical (highest)
	■	high
	■	low
Port Operating Status	Operating state of a PoE interface:
	■ off: PoE is disabled.
	■ on: Power is supplied for a PoE interface normally.
	■ power lack: The guaranteed remaining power of the PSE is
		not high enough to supply power for a critical PoE interface.
	■ power-deny: The PSE refuses to supply power. The power
		required by the powered device (PD) is higher than the
		configured power.
	■ power-itself: The external equipment is supplying power for
		itself.
	■ power-limit: The PSE is supplying a limited power. The power
		required by the PD is higher than the configured power and
		the PSE still supplies the configured power.
	■ Different models of device support different operating states.
Port IEEE class	PD power class: 0, 1, 2, 3, 4, and -
	The support for the - field depends on the device model.
Port Detection Status	Power detection state of a PoE interface:
	■ disabled: The PoE function is disabled.
	■ searching: The PoE interface is searching for the PD.

■ delivering-power: The PoE interface is supplying power for the PD.

■ fault: There is a fault defined in 802.3af.

■ test: The PoE interface is under test.

■ other-fault: There is a fault other than defined in 802.3af.

■ pd-disconnect: The PD is disconnected.

Different models of device support different detection states.