3Com MSR 30, MSR 50 manual Substitute voice dial program view, All, Number-substitute and rule

2644 CHAPTER 174: DIAL PLAN CONFIGURATION COMMANDS

substitute (voice dial program view)

Syntax	substitute { incoming-call outgoing-call } { called calling } list-number
	undo substitute { incoming-call outgoing-call } { called calling } { list-number
	all }
View	Voice dial program view
Parameter	incoming-call: Binds the calling/called number of incoming calls to the number
	substitution rule list.
	outgoing-call: Binds the calling/called number of outgoing calls to the number
	substitution rule list.
	called: Applies the number substitution rule to a called number.
	calling: Applies the number substitution rule to a calling number.
	all: Specifies all number substitution rule lists.
	list-number: Serial number of a number substitution rule list configured by using
	the number-substitutecommand), in the range of 1 to 2147483647.
Description	Use the substitute command to bind the calling/called number of
	incoming/outgoing calls to the specified number substitution rule list.
	Use the undo substitute incoming-callcommand to remove the binding.
	By default, no number substitution rule list is bound. That is to say, no number
	substitution is performed.
	You should follow these rules when using this command:
	■ At most 32 number substitution rule lists can be bound.
	■ The system does not stop searching the bound number substitution rule lists in
	sequence until one rule is applied successfully.
Related command:	number-substituteand rule.
n	Outgoing and incoming calls are relative to the IP network. Calls originated to the
	IP network are incoming calls, while those originated from the IP network or PSTN
	to PSTN are outgoing calls.
Example	# Apply number substitution rule list 5 to called numbers of incoming calls.
	<Sysname> system-view
	[Sysname] voice-setup
	[Sysname-voice] dial-program
	[Sysname-voice-dial] substitute incoming-call called 5