3Com MSR 50 Display dsl status, Syntax display dsl status interface atm interface-number, 133

133

Table 1 Description on the fields of the display dsl configuration command

Field	Description
Target Margin	Target margin
Line Rate	Line rate
PSD Mode	Power spectral density mode: symmetric or asymmetric
Power-Backoff	Power compensation
LinkCheck	State of link check: enable or disable
Actual Handshake Status	--
Local Handshake Status	--
Remote Handshake Status	--

display dsl status

Syntax display dsl status interface atm interface-number

View Any view

Parameter interface-number: Specifies a G.SHDSL interface to view the status information about.

Description Use the display dsl status command to display status information about the specified G.SHDSL interface.

Example # Display status information about ATM 5/0, which is a two-wire G.SHDSL interface that is up.

<Sysname> display dsl status interface atm 5/0

Operating	Mode: CPE
DSL Mode:	SHDSL Annex B
Configured	Wire Type:	2

Line A Statistics since last activation:

CRC:	0
LOSW Defect:	0
ES:	0
SES:	0
UAS:	0
TX EOC:	0
RX EOC:	0
Line A status:
Xcvr Op State:	Data Mode
Last Fail Op State:		0x00
Frame Sync:		in sync
Line Rate(Kbps):		2312
Wire Type:		2
SNR Margin(dB):	16.30
Loop Attenuation(dB):		0.00
RecvGain(dB):		6.07
TxPower(dBm):		9.50
Power Backoff:	enable
Power Backoff Level:		5
Tip/Ring Reversal:		Reversed
FrmOH Stat:		0x00
Rmt Encoder A :	0x0000016e