3Com MSR 50, MSR 30 manual Dialer route, 323

323

Description Use the dialer queue-lengthcommand to set the buffer queue length on the dial interface.

Use the undo dialer queue-lengthcommand to restore the default.

By default, no packets are buffered.

If no connection is available yet when a dial interface without a buffer queue receives a packet, it will drop the packet. Configured with a buffer queue, the dial interface will buffer the packet until a connection is available for packet sending.

Example # Set the buffer queue length to 10 on interface Serial 2/0.

<Sysname> system-view

[Sysname] interface serial 2/0

[Sysname-Serial2/0] dialer queue-length 10

dialer route

Syntax dialer route protocol next-hop-address [ mask network-mask-length ] [ broadcast user hostname ] * [ dial-number ] [ autodial interface interface-type interface-number ] *

undo dialer route protocol next-hop-address [ user hostname ] [ mask network-mask-length ] [ dial-number ] [ interface interface-type interface-number ]

View Dial interface (physical or dialer) view

Parameter protocol: Network protocol. At present, it can be ip only.

next-hop-address: IP address of dialed destination.

mask network-mask-length: Optional, mask length of the IP address of the dialed destination, in the range 0 to 32. If no mask length is specified, the default, 32, applies, where the next-hop-addressargument is handled as a host address. If you want to set the next-hop-addressargument to a network address, you must specify its mask length. Setting the next-hop-addressargument to 0.0.0.0 and the network-mask-lengthargument to 0 indicates any next hop address. For example, the dialer route ip 0.0.0.0 mask 0 8886 command indicates that you may call any IP address by dialing 8886.

user hostname: Remote username, a string of 1 to 80 characters used for authentication on incoming calls.

broadcast: Enables broadcast packets to pass through the link.

dial-number: Dial string for calling the remote end, a string of 1 to 30 characters.

autodial: If this keyword is used in a dialer route, you device will automatically attempt to dial according to the dialer route at certain intervals. The interval is set in the dialer autodial-intervalcommand and defaults to 300 seconds.