3Com MSR 30, MSR 50 manual Apply cost-type, Apply extcommunity

1190 CHAPTER 78: ROUTING POLICY COMMON CONFIGURATION COMMANDS

	<Sysname> system-view
	[Sysname] route-policy policy1 permit node 10
	[Sysname-route-policy] if-match interface serial 2/0
	[Sysname-route-policy] apply cost 120
apply cost-type
Syntax	apply cost-type { external internal type-1 type-2 }
	undo apply cost-type
View	Routing policy view
Parameters	external: IS-IS external route.
	internal: IS-IS internal route.
	type-1: Type-1 external route of OSPF.
	type-2: Type-2 external route of OSPF.
Description	Use the apply cost-typecommand to set a cost type for routing information.
	Use the undo apply cost-typecommand to remove the clause configuration.
	No cost type is set for routing information by default.
Examples	# Create routing policy policy1 with node 10, matching mode as permit. If a route
	matches tag 8, set the cost type for the route to IS-IS internal route.
	<Sysname> system-view
	[Sysname] route-policy policy1 permit node 10
	[Sysname-route-policy] if-match tag 8
	[Sysname-route-policy] apply cost-type internal
apply extcommunity
Syntax	apply extcommunity { rt route-target}&<1-16> [ additive ]
	undo apply extcommunity
View	Routing policy view
Parameters	rt route-target: Sets the route target extended community attribute, which is a
	string of 3 to 21 characters. route-targethas two forms:
	16-bit AS number: 32-bit self-defined number, for example, 101:3;
	32-bit IP address: 16-bit self-defined number, for example, 192.168.122.15:1.
	&<1-16>: Indicates the argument before it can be entered up to 16 times.