3Com MSR 30 manual Mpls rsvp-te timer retransmission, Related command mpls rsvp-tekeep-multiplier

1614 CHAPTER 96: MPLS TE CONFIGURATION COMMANDS

Parameter timevalue: Refresh interval, in the range 10 to 65535 seconds.

Description Use the mpls rsvp-te timer refresh command to configure the path/reservation state refresh interval.

Use the undo mpls rsvp-te timer refresh command to restore the default.

The default path/reservation state refresh interval is 30 seconds.

Related command: mpls rsvp-tekeep-multiplier.

Example # Set the path/reservation state refresh interval to 60 seconds.

<Sysname> system-view [Sysname] mpls

[Sysname-mpls] mpls rsvp-te timer refresh 60

mpls rsvp-te timer retransmission

Syntax	mpls rsvp-te timer retransmission { increment-value [ increment-value]
	retransmit-value[ retrans-timer-value ] } *
	undo mpls rsvp-te timer retransmission
View	Interface view
Parameter	increment-valueincrement-value: Increment value delta, in the range 1 to 10.
	The default is 1.
	retransmit-valueretrans-timer-value: Initial retransmission interval, in the range
	500 to 3000 milliseconds. The default is 500 milliseconds.
Description	Use the mpls rsvp-te timer retransmission command to enable RSVP
	message retransmission.
	Use the undo mpls rsvp-te timer retransmission command to restore the
	default.
	By default, RSVP message retransmission is disabled.
	On an interface enabled with the Message_ID (reliability) mechanism, you may
	configure RSVP message retransmission. After the interface sends an RSVP
	message, it waits for an acknowledgement. If no ACK is received before the initial
	retransmission interval (Rf seconds for example) expires, the interface resends the
	message. After that, the interface resends the message at an exponentially
	increased retransmission interval equivalent to (1 + Delta) ⋅ Rf seconds either until
	an acknowledgement is received or the retransmission attempt limit RI is reached.
	The Delta governs the speed with which the interface increases the retransmission
	interval.