3Com MSR 50, MSR 30 manual Isdn pri-slipwnd-size, 583

583

Parameter digits: Maximum number of digits that can be sent each time in overlap-sending mode, in the range 1 to 15. The default is 10.

Description Use the isdn overlap-sendingcommand to set the system to send the called

number information in the overlap mode on the ISDN interface.

Use the undo isdn overlap-sendingcommand to set the system to send the called information in full mode.

In overlap-sending mode, the digits of each called number will be sent separately and the number of the digits sent each time can be set using this command.

In full-sending mode, all the digits of each called number will be collected and sent at a time.

By default, full-sending mode applies.

You are not allowed to configure this command on an ISDN interface if there is still a call on it. This command can take effect only if it is configured when there is no call on the interface. Alternatively, you can manually disable the interface by executing the shutdown command, configure the command, and then enable the interface by executing the undo shutdown command. The operations, however, will lead to the disconnection of the call existing on the interface.

n OverlapQSIG. -sending is only suitable for five ISDN protocols: ANSI, DSS1, ETSI, NI, and

Example # Apply the overlap-sending function on the interface BRI 1/0 and set the number of digits allowed to send each time to 12 digits.

<Sysname> system-view

[Sysname] interface bri 1/0

[Sysname-Bri1/0] isdn overlap-sending 12

isdn pri-slipwnd-size

Syntax isdn pri-slipwnd-size window-size

isdn pri-slipwnd-size default

View Interface view

Parameter window-size: Slide window size in the range of 5 to 14. By default, the slide window size on PRI interfaces is 7.

Description Use the isdn pri-slipwnd-sizecommand to set the slide window size on a PRI interface.

Use the isdn pri-slipwnd-size default command to restore the default slide window size on the PRI interface.