414CHAPTER 23: GARP CONFIGURATION COMMANDS

Each time a device on the network receives a LeaveAll message, it resets its leaveall timer. Therefore, a GARP application entity may send LeaveAll messages at the interval set by its leaveall timer or the leaveall timer on another device on the network, whichever is smaller.

Related command: display garp timer.

Example # Set the leaveall timer to 100 centiseconds, assuming that the leave timer is 60 centiseconds.

<Sysname> system-view

[Sysname] garp timer leaveall 100

reset garp statistics

Syntax

reset garp statistics [ interface interface-list]

View

User view

Parameter

interface interface-list: Specifies an Ethernet port list, in the format of

 

{ interface-type interface-number [ to interface-type interface-number ] }&<1-10>,

 

where &<1-10> indicates that you can specify up to 10 port ranges. A port range

 

defined without the to interface-typeinterface-numberportion comprises only

 

one port.

Description

Use the reset garp statistics command to clear GARP statistics of the specified

 

or all ports.

 

Note that:

 

If the interface interface-listkeyword-argument combination is not specified,

 

this command clears the GARP statistics of all the ports.

 

If the interface interface-listkeyword-argument combination is specified, this

 

command clears the GARP statistics of the specified ports.

Related command:

display gvrp statistics.

Example

# Clear statistics about GARP on all ports.

 

<Sysname> reset garp statistics

Page 414
Image 414
3Com MSR 30, MSR 50 manual Reset garp statistics interface interface-list, Display gvrp statistics