3Com MSR 30, MSR 50 manual Card-digit, Cdr, Syntax card-digit card-digit Undo card-digit

2728 CHAPTER 180: VOICE RADIUS CONFIGURATION COMMANDS

#Restore the default method of collecting digits of called numbers for the access number 17909.

[Sysname-voice-dial-anum17909] undo callednumber receive-method

card-digit

Syntax card-digit card-digit

undo card-digit

View Access number view

Parameter card-digit: Number of digits in a card number, in the range of 1 to 31.

Description Use the card-digitcommand to configure the number of digits in a card number for some access number in the card number/password process.

Use the undo card-digitcommand to restore the default.

By default, the number of digits in a card number is 12 only when an access number is already configured for the card number/password process (by using the process-configcommand).

Note that:

■This command is used to configure the number of digits in a card number for the card number/password process. Once the number of digits is fixed, all users who use the access number must enter a fixed-length card number. Otherwise, the voice gateway will report an error.

■The card-digitcommand is available in access number view only after you use the process-configcommand to specify the dialing process as card number/password process.

Related command: gw-access-numberand process-config.

Example # Specify the number of digits in a card number as 10 for the access number 17909.

<Sysname> system-view [Sysname] voice-setup [Sysname-voice] dial-program

[Sysname-voice-dial] gw-access-number 17909 [Sysname-voice-dial-anum17909] process-config cardnumber

[Sysname-voice-dial-anum17909] card-digit 10

cdr

Syntax cdr { buffer size-number duration time-length threshold percentage }