3Com MSR 30, MSR 50 manual Display mpls label label-value1 to label-value2 all

1516 CHAPTER 95: MPLS BASICS CONFIGURATION COMMANDS

Table 368 Description on the fields of the display mpls interface command

Field	Description
Status	Status of the interface
TE Attr/TE Attribute	Whether TE is enabled on the interface
LSPCount	Number of LSPs on the interface
CR-LSPCount	Number of CR-LSPs on the interface
FRR	Whether FRR is enabled on the interface. If FRR is enabled, the
	output will also include the bound tunnels.

n For1565.information about FRR, refer to “MPLS TE Configuration Commands” on page

display mpls label

Syntax	display mpls label { label-value1[ to label-value2] all }
View	Any view
Parameter	all: Specifies all labels.
	label-value1: Specifies a label or, when used with the label-value2argument, the
	start label of a range of labels. The value of this argument ranges from 16 to
	8191.
	to label-value2: End label of a range of labels, in the range 16 to 8191.
	all: Specifies all labels.
Description	Use the display mpls label command to display the status of one or more
	specified or all labels.
Example	# Display the status of a specified label.
	<Sysname> display mpls label 1280
	Label alloc state: ’.’ means not used, ’$’ means used
	-------------Dynamic Label--------------------------------
	1280:.
	# Display the status of all labels.
	<Sysname> display mpls label all
	---------------------------------------------------------------------
	Label alloc state: ’.’ means not used, ’$’ means used
	------------------------Static Label	---------------------------------
	16:	........ ........ ........ ........
	976:	........ ........
	------------------------Dynamic Label--------------------------------
	1024: $ $$	........ ........ ........ ........
	1088: