2685

fax level

Syntax fax level level

undo fax level

View POTS/VoIP/VoFR entity view

Parameter level: Level of the energy transmitted by a gateway carrier in dBm, in the range of -60 to -3. The greater the value is, the higher the energy is. The smaller the value is, the higher the attenuation is.

Description Use the fax level command to configure the transmit energy level of a gateway carrier.

Use the undo fax level command to restore the default.

By default, the transmit energy level of a gateway carrier is -15 dBm.

Usually the default transmit energy level of a gateway carrier is acceptable. If fax still cannot be sent when other configurations are correct, try to adjust the transmit energy level.

Example # Set the transmit energy level of the gateway carrier to -20 dBm.

<Sysname> system-view [Sysname] voice-setup [Sysname-voice] dial-program [Sysname-voice-dial] entity 4 pots

[Sysname-voice-dial-entity4] fax level -20

fax local-train threshold

Syntax fax local-train threshold threshold

undo fax local-train threshold

View POTS/VoIP/VoFR entity view

Parameter threshold: Fax local training threshold in percentages, in the range of 0 to 100.

Description Use the fax local-train threshold command to configure the fax local training threshold.

Use the undo fax local-train threshold command to restore the default.

By default, the fax local training threshold is 10.

The point-to-point training means that the gateway does not participate in the rate training between two facsimile terminals. In this mode, rate training is

Page 2685
Image 2685
3Com MSR 50, MSR 30 manual Fax level, Fax local-train threshold, Syntax fax level level Undo fax level, 2685