3Com MSR 50, MSR 30 manual Network Ospf area view, Nssa, Related commands ospf, 1141

1141

Description Use the maximum-routescommand to specify the maximum route number of a specified type: inter-area, intra-area, external.

Use the undo maximum-routescommand to restore the default route maximum value of a specified type.

Examples # Specify the maximum number of intra-area routes as 500.

<Sysname> system-view

[Sysname] ospf 100

[Sysname-ospf-100] maximum-routes intra 500

network (OSPF area view)

Syntax network ip-address wildcard-mask

undo network ip-address wildcard-mask

View OSPF area view

Parameters ip-address: IP address of a network

wildcard-mask: Wildcard mask of the IP address. For example, the wildcard mask for the subnet mask 255.0.0.0 is 0.255.255.255.

Description Use the network command to enable OSPF on the interface attached to the specified network in the area.

Use the undo network command to disable OSPF on an interface.

By default, an interface neither belongs to any area nor runs OSPF.

You can configure one or multiple interfaces in an area to run OSPF. Note that the interface’s primary IP address must fall into the specified network segment to make the interface run OSPF. If only the interface’s secondary IP address falls into the network segment, the interface cannot run OSPF.

Related commands: ospf.

Examples # Specify the interface whose primary IP address falls into 131.108.20.0/24 to run OSPF in Area 2.

<Sysname> system-view [Sysname] ospf 100 [Sysname-ospf-100] area 2

[Sysname-ospf-100-area-0.0.0.2] network 131.108.20.0 0.0.0.255

nssa

Syntax nssa [ default-route-advertise no-import-route no-summary ]*