3Com MSR 30, MSR 50 Trip retransmit timer retransmit-time-value, Undo trip retransmit timer

1184 CHAPTER 77: RIP CONFIGURATION COMMANDS

View	RIP view
Parameters	retransmit-count-value:Upper limit for retransmitting an Update Request or
	Update Response, in the range 1 to 3600.
Description	Use the trip retransmit count command to configure the upper limit for
	retransmitting an Update Request or Update Response.
	Use the undo validate-source-addresscommand to restore the default.
	The default upper limit is 36.
Examples	# Configure an upper limit of 20 for retransmitting an Update Request or Update
	Response.
	<Sysname> system-view
	[Sysname] rip 100
	[Sysname-rip-100] trip retransmit count 20

trip retransmit timer

Syntax	trip retransmit timer retransmit-time-value
	undo trip retransmit timer
View	RIP view
Parameters	retransmit-time-value:Interval in seconds for retransmitting an Update Request or
	Update Response, in the range 1 to 3600.
Description	Use the trip retransmit timer command to configure the interval for
	retransmitting an Update Request or Update Response.
	Use the undo validate-source-addresscommand to restore the default.
	The default interval is 5 seconds.
	For two routers on an analog dial-up link, the difference between retransmission
	intervals on the two ends must be bigger than 50 seconds; otherwise, they can
	not become TRIP neighbors.
Examples	# Configure an interval of 80 seconds for retransmitting an Update Request or
	Update Response.
	<Sysname> system-view
	[Sysname] rip 100
	[Sysname-rip-100] trip retransmit timer 80