3Com MSR 30 manual Display mpls te tunnel path, Lsr-id Ingress LSR ID, in dotted decimal notation

1596 CHAPTER 96: MPLS TE CONFIGURATION COMMANDS

Table 414 Description on the fields of the display mpls te tunnel verbose command

Field	Description
No	Number
LSP-Id	LSP ID of tunnel
Tunnel-Name	Tunnel name configured on the ingress node
Destination	Destination router ID
In-Interface	Incoming interface
Out-Interface	Outgoing interface
Tunnel BW	Tunnel bandwidth
Class Type	Service class type
Ingress LSR-Id	Ingress LSR ID
Setup-Priority	Setup priority of link
Hold-Priority	Holding priority of link
Sign-Protocol	Signaling protocol
Resv Style	Reservation style
IncludeAnyAff	Any affinity properties that must be included
ExcludeAllAff	Link properties that are excluded
IncludeAllAff	All link affinity properties that must be included
Created Time	Time when the tunnel was created

display mpls te tunnel path

Syntax	display mpls te tunnel path [ tunnel-name tunnel-name] [ lsp-id lsr-idlsp-id]
View	Any view
Parameter	tunnel-nametunnel-name: Tunnel name, a string of 1 to 63 characters.
	lsr-id: Ingress LSR ID, in dotted decimal notation.
	lsp-id: LSP ID, in the range 1 to 65535.
Description	Use the display mpls te tunnel path command to display the path or paths
	that the specified or all MPLS TE tunnels traverse on this node.
Example	# Display the paths that all MPLS TE tunnels traverse.
	<Sysname> display mpls te tunnel path
	Tunnel Interface Name Tunnel0:
	Lsp ID : 1.1.1.9:10
	Hop information:
	Hop 0: 192.1.1.1;
	Hop 1: 12.1.1.2;
	Hop 2: 10.202.2.2.