3Com MSR 30, MSR 50 manual Display ipsec statistics, Syntax display ipsec statistics, Icmp

2128 CHAPTER 140: IPSEC CONFIGURATION COMMANDS

<Sysname> display ipsec session tunnel-id 5

------------------------------------------------------------

total sessions : 1

------------------------------------------------------------

tunnel-id : 5

session idle duration/total duration (sec) : 30/300

session flow :	(4 times matched)
Sour Addr : 12.12.12.2		Sour Port:	0	Protocol : 1
Dest Addr : 13.13.13.2		Dest Port:	0	Protocol : 1
Table 566 Description on the fields of the display ipsec session command
Field	Description
total sessions	Total number of IPSec sessions
tunnel-id	IPSec tunnel ID, same as the connection-id of the IPSec SA
session idle time	Idle duration of the IPSec session in seconds
total duration	Total duration of the IPSec session in seconds, defaulted to 300
	seconds
session flow	Flow information of the IPSec session
times matched	Total number of packets matching the IPSec session
Sour Addr	Source IP address of the IPSec session
Dest Addr	Destination IP address of the IPSec session
Sour Port	Source port number of the IPSec session
Dest Port	Destination port number of the IPSec session
Protocol	Protocol number of the IPSec protected data flow, for example, 1 for
	ICMP

display ipsec statistics

Syntax display ipsec statistics

View Any view

Parameter None

Description Use the display ipsec statistics command to display IPSec packet statistics.

Related command: reset ipsec statistics.

Example # Display IPSec packet statistics.

<Sysname> display ipsec statistics the security packet statistics:

input/output security packets: 5124/8231

input/output security bytes: 52348/64356

input/output dropped security packets: 0/0 dropped security packet detail:

not enough memory: 0

can’t find SA: 0

queue is full: 0

authentication has failed: 0

wrong length: 0