3Com MSR 30, MSR 50 manual Portal auth-network, Undo portal auth-network network-addressall

2074 CHAPTER 135: PORTAL CONFIGURATION COMMANDS

000d-88f8-0eab	2.2.2.2	0	Ethernet1/0
Total 1 user(s) matched, 1 listed.
Table 543 Description on the fields of the display portal user command
Field		Description
Index		Index of a portal user
State		Current state of a portal user
SubState		Current sub-state of a portal user
MAC		MAC address of a portal user
IP		IP address of a portal user
Vlan		VLAN where a portal user is
Interface		Interface to which a portal user is attached
Total 1 user(s) matched, 1 listed		Counts of portal users

portal auth-network

Syntax portal auth-networknetwork-address { mask-length mask }

undo portal auth-network { network-addressall }

View Interface view

Parameter network-address: Authentication subnet address.

mask-length: Length of the subnet mask, in the range of 0 to 32.

mask: Subnet mask, in dotted decimal notation.

all: Specifies all authentication subnets.

Description Use the portal auth-networkcommand to configure a portal authentication subnet.

Use the undo portal auth-networkcommand to remove the configuration.

Note that this command is applicable to only Layer 3 authentication. The portal authentication subnet for direct authentication is any source IP address, and the portal authentication subnet for re-DHCP authentication is the one determined by the private IP address of the interface.

By default, the portal authentication subnet is 0.0.0.0/0, meaning to authenticate users in all subnets.

Example # Set the portal authentication subnet to 10.10.10.0/24.

<Sysname> system-view

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0] portal auth-network 10.10.10.0 24