3Com MSR 30 Stp pathcost-standard, Examples # Enable No Agreement Check on Ethernet 1/1, Standard

616CHAPTER 38: MSTP CONFIGURATION COMMANDS

By default, No Agreement Check is disabled.

	The No Agreement Check feature can take effect only on the root port or
n alternate port.
Examples	# Enable No Agreement Check on Ethernet 1/1.
	<Sysname> system-view
	[Sysname] interface ethernet 1/1
	[Sysname-Ethernet1/1] stp no-agreement-check
stp pathcost-standard
Syntax	stp pathcost-standard { dot1d-1998 dot1t legacy }
	undo stp pathcost-standard
View	System view
Parameters	dot1d-1998: The device calculates the default path cost for ports based on IEEE
	802.1D-1998.
	dot1t: The device calculates the default path cost for ports based on IEEE 802.1t.
	legacy: The device calculates the default path cost for ports based on a private
	standard.
Description	Use the stp pathcost-standardcommand to specify a standard for the device to
	use when calculating the default path cost of the link connected with the device

Use the undo stp pathcost-standardcommand to restore the default setting of the calculation standard.

The default standard used by the device is legacy.

Note that if you change the standard that the device uses in calculating the default path cost, the port path cost value set through the stp cost command will be out of effect.

Table 110 Link speed vs. path cost

Link speed	Duplex state	802.1D-1998	IEEE 802.1t	Private standard
0	-	65535	200,000,000	200,000
10Mbps	Single Port	100	2,000,000	2,000
	Aggregated	100	1,000,000	1,800
	Link 2 Ports	100	666,666	1,600
	Aggregated
		100	500,000	1,400
	Link 3 Ports

Aggregated

Link 4 Ports