3Com MSR 30, MSR 50 manual FieldDescription, Dslam

■

148CHAPTER 6: ADSL INTERFACE CONFIGURATION COMMANDS

Current Rate(kbps):	0	0
Latency:	Intl	Intl

Table 5 Description on the fields of the display dsl status command

FieldDescription

Line Status	Line status of the ADSL interface, which can be:
	■ No Defect, indicating the normal state
	■ Loss Of Frame, indicating an error concerning frame
	■ Loss Of Signal, indicating an error concerning signal
	■ Loss Of Power, indicating an error concerning power supply
	■ Loss Of Signal Quality, indicating an error concerning signal quality
	■ Unknown, indicating an unknown error
Training Status	Training status of the ADSL interface, which can be:
	■ Idle, indicating the interface is idle
	■	G.994	Training, indicating a G.994 training
	■	G.992	Started, indicating a G.992 training is launched
	■	G.922	Channel Analysis, indicating G.922 channel analysis is going on
	■	G.992	Message Exchange, indicating G.992 message exchange is
		going on
	■ Showtime, indicating normal data exchange
	■	Unknown

The following information appears after the line is activated.

Active Params Standard, connection standard adopted by the interface and the

DSLAM

■SNR, signal-to-noise ration of the ADSL link

■Attr, attenuation of the ADSL link

■Pwr, transmit power of the ADSL module, in dbm

■Current Rate, uplink/downlink rate between the ADSL interface and the DSLAM, in kbps

■Latency, Way in which the interface and the DSLAM are connected, which can be “Intl” (cross-over) and “Fast”

display dsl version

Syntax display dsl version interface atm interface-number

View Any view

Parameter interface-number: Specifies a DSL interface to view the version and support capability information on it.

Description Use the display dsl version command to display the DSL version and support capabilities of an interface.

Example # Display the ADSL version information of interface ATM 2/0.

<Sysname> display dsl version interface atm 2/0 Adsl board chipset and version info: