1007

Parameters None

Description Use the reflect between-clientscommand to enable route reflection between clients.

Use the undo reflect between-clientscommand to disable this function.

By default, route reflection between clients is enabled.

After a route reflector is configured, it reflects the routes of a client to other clients. If the clients of a route reflector are fully meshed, you need disable route reflection between clients to reduce routing costs.

Related commands: reflector cluster-id (BGP view) and peer reflect-client(BGP/BGP-VPN instance view).

Examples # Disable route reflection between clients.

<Sysname> system-view [Sysname] bgp 100

[Sysname-bgp] undo reflect between-clients

reflector cluster-id (BGP view)

Syntax reflector cluster-id cluster-id

undo reflector cluster-id

View BGP view

Parameters cluster-id: Cluster ID of the route reflector, an integer from 1 to 4294967295 (the integer is translated into an IP address by the system) or an IP address.

Description Use the reflector cluster-idcommand to configure the cluster ID of the route reflector.

Use the undo reflector cluster-idcommand to remove the configured cluster

ID.

By default, each route reflector uses its router ID as the cluster ID.

Usually, there is only one route reflector in a cluster. The router ID of the route reflector is the ID of the cluster. You can configure multiple route reflectors to improve the stability of the network. In this case, using this command can configure the identical cluster ID for all the route reflectors to avoid routing loops.

Related commands: reflect between-clients (BGP view) and peer reflect-client(BGP/BGP-VPN instance view).

Examples # Set the cluster ID to 80.

Page 1007
Image 1007
3Com MSR 50, MSR 30 manual Reflector cluster-id BGP view, Examples # Disable route reflection between clients, 1007