3Com MSR 30, MSR 50 manual X29 timer inviteclear-time

472CHAPTER 26: LAPB AND X.25 CONFIGURATION COMMANDS

<Sysname> system-view [Sysname] x25 switching

[Sysname] interface ethernet 1/0 [Sysname-Ethernet1/0] ip address 10.1.1.1 255.255.255.0

[Sysname-Ethernet1/0] quit [Sysname] interface serial 2/0

[Sysname-Serial2/0] link-protocol x25 dce ietf

[Sysname-Serial2/0] x25 xot pvc 1 10.1.1.2 interface serial 2/0 pvc 2

x29 timer inviteclear-time

Syntax x29 timer inviteclear-time seconds

undo x29 timer inviteclear-time

View System view

Parameter seconds: Delay time in seconds, in the range 5 to 2147483. The delay waiting for response after inviting PAD clear procedure.

Description Use the x29 timer inviteclear-timecommand to set the delay waiting for response after the PAD clear procedure is initiated. Upon expiration of this timer, the server aborts the connection by force and starts X.25 clear procedures.

Use the undo x29 timer inviteclear-timecommand to restore the default.

The default is 5 seconds.

The server of X.25 PAD may send an Invite Clear message to the client, for example, after receiving a quit request from client or in order to release the link. At the same time, a timer is started. If no response is received upon expiration of the timer, the server clears the link.

Example # Set the delay waiting for response after the PAD clear procedure is initiated to 1000 seconds.

<Sysname> system-view

[Sysname] x29 timer inviteclear-time 1000