408CHAPTER 22: FRAME RELAY CONFIGURATION COMMANDS

Example # Clear all the frame relay dynamic address maps.

<Sysname> reset fr inarp

reset fr pvc

Syntax reset fr pvc interface serial interface-number[ dlci dlci-number]

View User view

Parameter interface-number: Interface number.

dlci dlci-number: DLCI assigned to an FR interface. The dlci-numberargument is in the range 16 to 1007. Note that DLCI 0 through 15 and 1008 through 1023 are reserved for special use and are thus unavailable.

Description Use the reset fr pvc command to clear the statistics on a PVC.

Example # Clear PVC statistics on Serial 2/0.

<Sysname> reset fr pvc interface serial 2/0

timer hold

Syntax timer hold seconds

undo timer hold

View Interface view

Parameter seconds: Value of T391 parameter at DTE side, which ranges from 0 to 32767 in seconds. 0 indicates that the LMI protocol is disabled.

Description Use the timer hold command to configure T391 parameter at the DTE side.

Use the undo timer hold command to restore the default.

By default, the parameter is 10 seconds.

The parameter is a time variable that defines the interval of Status-Enquiry packet sent by DTE.

Related command: fr lmi t392dce.

Example # Configure that frame relay interface Serial 2/0 to operate in DTE mode, and set the value of T391 parameter to 15 seconds.

<Sysname> system-view

[Sysname] interface serial 2/0

[Sysname-Serial2/0] link-protocol fr

Page 408
Image 408
3Com MSR 30, MSR 50 Reset fr pvc, Example # Clear all the frame relay dynamic address maps, Related command fr lmi t392dce